http://www.ybapublications.co.uk/scnews/wordpress/?p=982 Latest news from around the tracks Wed, 01 Sep 2010 18:34:28 +0200 hourly 1 http://wordpress.org/?v=3.0.1 http://www.ybapublications.co.uk/scnews/wordpress/?p=982&cpage=1#comment-376 steve soper Fri, 27 Feb 2009 19:05:11 +0000 http://www.ybapublications.co.uk/scnews/wordpress/?p=982#comment-376 last time i see this axle it was fitted to in a car designed by vince o'connor and if my memory is correct a firm in london built it to his design, vince then convinced everyone it was a good replacement using the original centre section and it would be very inexpensive to build, trouble was vince being vince he had other intentions like cambering the axle and inserting a uj in the diff think he found a way of using the granada rear drive shaft one, in the end it was outlawed by pri. recall dave coventry checking it and he found the outside wheel had 3/8 camber, think also if you check short circuit some years past they done an article by mr huggett on the same axle cannot remember the year. best of luck with the prodject. steve last time i see this axle it was fitted to in a car designed by vince o’connor and if my memory is correct a firm in london built it to his design, vince then convinced everyone it was a good replacement using the original centre section and it would be very inexpensive to build, trouble was vince being vince he had other intentions like cambering the axle and inserting a uj in the diff think he found a way of using the granada rear drive shaft one, in the end it was outlawed by pri. recall dave coventry checking it and he found the outside wheel had 3/8 camber, think also if you check short circuit some years past they done an article by mr huggett on the same axle cannot remember the year.
best of luck with the prodject.
steve

]]>